skilsaw SPT79A, Инструкция по эксплуатации и безопасности

Страница: 12 / 56

12
FOLDING HANDLE
1. To unfold the switch handle, depress the
middle control knob (on the left side) and
rotate the upper arm 180° counterclockwise.
When fully open, the control knob will click
out in the locked position.
2. Depress the lower control knob (on the right
side) and rotate the arm assembly 130°
clockwise. When correctly positioned, the
control knob will click out in the locked posi-
tion; the arm assembly will be at an approxi-
mate 50° angle.
3. To extend the switch handle, loosen the
control knob on the top of the arm assembly.
Slide the switch handle out to one of the five
preset detent positions, and then tighten the
control knob.
4. Assemble the side handle onto the desired
position (left or right side) by rotating the
handle clockwise into the threaded insert.
Switch
When starting the tool,
hold the switch handle
with one hand and the side handle with the
other. Tip the tool back on the two rear
wheels. The tool should be in the UP posi-
tion with the cut-off wheel above the mate-
rial to be cut. The torque from the motor can
cause the tool to twist.
To turn tool ON, squeeze the trigger switch. To
turn the tool OFF, release the trigger switch,
which is spring loaded and will return to the off
position automatically.
Your tool should be running at full speed BE-
FORE starting the cut, and turned off only
AFTER completing the cut. To increase switch
life, do not turn switch on and off while cutting.
Fig. 5
Fig. 6