11
10
12
6
12
FIG. 18
FIG. 19
WORK
BOIS
MADERA
LOOKING DOWN ON SAW
VUE DE DESSUS
VISTA HACIA ABAJO SOBRE LA SIERRA
FIG. 15
FIG. 16
32.
Attaching Blade Guard
1. From among the loose parts, locate the following hardware
(Fig. 15).
ITEM
DESCRIPTION
QTY.
6
Blade Guard and Spreader
1
13
Spreader Support Assembly
1
14
Flat Washer
1
15
Lockwasher (1/4" External)
1
16
Hex Bolt (1/4-20 x 2")
1
Note:
Adjustments to the following bolt & screws can be done
using the small end of arbor wrench (see page 24) or a 10 mm
wrench (see page 7).
2. Align flats on inside of speader support assembly
13
with flats
on end of pivot rod
7
located on back side of table
8
and fasten to
pivot rod
7
using the 1/4-20 x 2" long hex bolt
16
, 1/4" external
tooth lockwasher
15
and flat washer
14
(Fig. 15).
3. Remove flanged hex bolt
21
and remove clamping plate
22
.
(Fig. 16).
4. Position spreader
6
over bumps
9
, then position clamping plate
22
over bumps
9
and securely tighten flanged hex bolt
21
.
(Fig. 16).
IMPORTANT:
The Spreader
6
must always be IN LINE with the
sawblade
10
. The spreader
6
is thinner than the width of the KERF
11
by approximately three thicknesses of paper
18
on each side
of the spreader
6
(Fig. 19).
5. Loosen hex nut
20
, then flanged hex bolts
23
with the 10 mm
open end wrench. Loosen set screw
19
with a flat tip screwdriver.
(Fig. 18).
6. Place rip fence
2
on table, lift up ANTIKICKBACK PAWL and
CAREFULLY move fence
2
against the blade so that it is parallel to
the blade, and just touches tips of saw teeth
10
, and lock fence
2
in this position (Fig. 18).
7. Make two folds in a small piece (6" x 6") of ordinary newspaper
making three thicknesses (Fig. 17). The folded paper
18
will be
used as a “spacing gauge” (Fig. 18).
8. Insert folded paper
18
between SPREADER and FENCE. Hold
spreader firmly against fence (Fig. 18).
9. First lightly tighten the flanged hex bolts
23
and then the set
screw
19
. Recheck squareness of spreader to table and
parallelism to blade. Readjust if necessary.
10. After proper alignment adjustment is made, tighten hex nut
20
and securely tighten flanged hex bolts
23
.
NOTE:
Always be sure the spreader stays in line with blade when
the blade is tilted at any angle.
Assembly
14
15
16
13
6
7
8
21
22
9
FIG. 17
18
20
19
23
23
2
6
18
10
