DRIVE SYSTEM
Belt Guard Removal and
Installation
WARNING
Never operate engine:
– without shields and belt guard
securely installed
– with hood opened or removed.
Never attempt to make adjust-
ments to moving parts while en-
gine is running.
Skandic LT/LT E
1.
Remove tether cord cap.
2.
Open hood. Pull out clip, then
open pin retainer. Remove belt
guard.
1
A29D1RB
2
1. Clip
2. Pin retainer
Skandic WT/SWT/SUV/
Expedition TUV 600 HO SDI
– Remove tether cord cap.
– Open hood. Remove both retaining
pins, then belt guard.
A29D0FA
1
TYPICAL
1. Retaining pins
Expedition TUV V-1000
– Remove tether cord cap. Open en-
gine compartment.
– Loosen collar screw on air silencer
grommet.
– Disconnect engine vent hose from
air silencer.
– Disconnect air temperature sensor.
– Unhook latch from air silencer. Re-
move air silencer.
A29D2RA
3
1
4
2
1. Collar screw
2. Vent hose
3. Air temperature sensor
4. Latch
At installation do not forget to con-
nect air temperature sensor otherwise
a trouble code will appear.
90
______________________
Содержание Skandic Series
