Ski-Doo Mini Z 2000, Руководство по ремонту

Страница: 149 / 160

Section 09 BODY/FRAME
Subsection 03 (FRAME)
09-03-2
MMR2000_135_09_03A.FM
FRAME CLEANING
Clean frame no. 1 , tunnel no. 2 and bumpers
no. 3 with appropriate cleaners and rinse with
high pressure hose.
Touch up all metal spots where paint has been
scratched off. Spray all bare metal parts of vehicle
with metal protector.
Seat Removal/Replacement
Seat no. 4 is retained to tunnel with 4 wood
screws no. 5 . All screws must be removed from
inside tunnel.
To remove both front wood screws no. 5 , detach
rear suspension from tunnel, as described in sec-
tion 07 REAR SUSPENSION.
CAUTION: Ensure that 4 wood screws no. 5
have been removed before removing seat.
Seat Cleaning
It is recommend to clean the seat no. 4 with a so-
lution of warm soapy water , using a soft clean
cloth.
CAUTION: Avoid use of harsh detergents such
as strong soaps, degreasing solvents, abrasive
cleaners, paint thinners, etc. that may cause
damage to the seat cover.
FRAME WELDING
Steel Frame:
– electric welding
– amperage: 70-110 A
– voltage: 20-24 V
– rod: E-7014 (3/32 in)
CAUTION: If welding is to be done near plastic
material, it is recommended to either remove
the part from the area or to protect it with alu-
minum foil to prevent damage.
FRAME COMPONENT
REPLACEMENT
Drilling Procedure
For proper drilling instructions and to prevent pre-
mature wear, follow the procedure below.
Always use a variable speed electric drill.
Center the drill bit on the rivet hole and drill.
Maintain a slow to medium speed at all times
when drilling. The proper speed is attained when
a constant breaking chip is ejected.
NOTE: To increase bit life, use Bombardier syn-
thetic chaincase oil (P/N 413 803 300) as a cutting
oil.
CAUTION: High speed drilling will cause exces-
sive heat which may destroy the cutting edge of
the bit, therefore avoid using pneumatic drills.