104
TROUBLESHOOTING
SYMPTOM
:
Engine turns over but fails to start.
POSSIBLE CAUSES
WHAT TO DO
1. Engine cut-out switch or tether
switch is in the OFF position.
Place all switches in the ON position.
2. Mixture not rich enough to start
cold engine.
Check fuel tank level and check start-
ing procedure, particularly use of the
choke.
3. Flooded engine
(spark plug wet when removed).
Do not choke. Remove wet spark plug,
turn off engine cut-out switch and
crank engine several times. Install
clean dry properly gapped spark plug.
Start engine following usual starting
procedure. If engine continues to
flood, see an authorized SKI-DOO
dealer.
4. No fuel to the engine
(spark plug dry when removed).
Check fuel tank level; turn fuel valve
on if applicable; check fuel filter; re-
place if clogged; check condition of
fuel and impulse lines and their con-
nections. A failure of the fuel pump or
carburetor has occurred. Contact an
authorized SKI-DOO dealer.
5. Spark plug/ignition (no spark).
Remove spark plug(s) then reconnect
to spark cap. Check that engine cut-
out switch is at the ON position and
the tether cut-out switch cap is
snapped over the receptacle. Start en-
gine with spark plug(s) grounded to
engine away from spark plug hole. If
no spark appears, replace spark plug
with new ones properly gapped. If
trouble persists, contact an authorized
SKI-DOO dealer.
6. Engine compression.
As the engine is pulled over with the
rewind starter, “cycles” of resistance
should be felt as piston goes past
top dead center (each piston on multi-
cylinder engines). If no pulsating re-
sistance is felt, it suggests a major loss
of compression. Contact an authorized
SKI-DOO dealer.
Mmo2002-003a.book Page 104 Friday, February 2, 2001 1:47 PM
Содержание 2002 Mach Z STD
