SKF TWIM 15, Инструкция по эксплуатации, Страница: 9 / 132

7 EN
4. Installation
A q
ualiied electrician must install a suitable plug.
Make sure that the line voltage is within the
speciied range depending on the heater type.
TWIM 15/230V 230V, 50Hz
Mains supply terminal Cable color
Neutral Blue
Line Brown
Ground Not connected
TWIM 15/110V 110V, 60Hz
Mains supply terminal Cable color
Neutral White
Line Black
Ground Not connected
I M P O R TA N T:
The main switch in the heater is not a safety switch.
The heater needs to be unplugged from the mains
to perform any repair.
If the mains cable is damaged, it must be replaced.
5. Preparation for use
• Place the TWIM 15 in horizontal position on a
surface.
• Connect the mains plug to a suitable power
supply.
• Carefully place the workpiece to be heated in
the center of the top plate.
• The heater is designed to heat up one
component at a time.
• If used in Temperature Mode , plug the
temperature probe into the connector.
Place the magnetic tip of the probe on the
horizontal surface of the bearing inner ring or
on the innermost surface of the workpiece.
• Switch on the heater from the main switch,
which is located at the rear right of the heater.
The power LED will be lit for few seconds until
the entire display and heater will be ready.
• Select the right heating mode and settings.
• Once you have inished heating the component,
attach the magnetic probe tip to the metallic
sheet on the heater’s housing. This is the
temperature probe’s parking spot, located at the
rear left of the heater.