SKF TKSA 40, Инструкция по эксплуатации

Страница: 25 / 432

24 SKF TKSA 40
The result is interpreted according to the table below:
OK. Within the maximum acceptable misalignment values
NOT OK. Within double the maximum acceptable misalignment values
NOT OK. Out of double the maximum acceptable misalignment values
• Horizontal adjustment:
Select the horizontal adjustment icon. Press OK to continue.
Rotate the shaft to position the measuring units at the 3 o’clock position.
Press OK to confirm the 3 o’clock position.
Fig. 25 Horizontal adjustment live values
Adjust the horizontal positioning of the moveable machine, following the display on the
screen.
The adjustment can be done by moving the moveable machine sideways, according to
the direction and feet values displayed on the screen.
Follow the live changes of the coupling values and alignment status compared with the
maximum acceptable misalignment value (only available when a rotational speed has
been informed, see section 3.4 and 3.6)
Next steps:
From this module you can navigate to:
Measurement module, to check the final status of the alignment after correction
(recommended). See section 3.5
{
Vertical
adjustment
Measurement
module
Soft foot mode
Indication of the alignment status
compared with the maximum
acceptable misalignment value
MU marked ‘M”
raw value
MU marked ‘S”
raw value
File manager
Rear feet horizontal
adjustment value
Front feet horizontal
adjustment value
Direction of the
required adjustment
Parallel/ offset
Horizontal
plane coupling
values
Angular