SNB-K2A AUTOMATIC EDGE BANDER MANUAL
4
6/2016
17.
NEVER LEAVE THE MACHINE RUNNING OR UNATTENDED. TURN POWER OFF. Do not
leave the machine until it comes to a complete stop.
18.
NEVER OPERATE THE MACHINE WHEN TIRED, OR UNDER THE INFLUENCE OF DRUGS
OR ALCOHOL. Full mental alertness is required at all times when running a machine.
19.
NEVER ALLOW UNSUPERVISED OR UNTRAINED PERSONNEL TO OPERATE THE
MACHINE. Make sure any instructions given in regards to the operation of the
machine is safe and clearly understood.
2.
SPECIFICATIONS & FEATURES
The SNB-K2A Automatic Edge bander is able to handle an array of material from PVC, ABS,
laminates, wood tape, and wood strips with thickness ranges from 0.5mm–3.0mm thick on
panels ranging anywhere from 14 - 40mm thick. For tapes up to 3 mm and plastic laminate
strips.
Features:
(a)
Easy to adjust, high quality finishing
(b)
Simultaneous adjustment for tape thickness, guide and gluing roller by a
single meter.
(c)
Automatic feeder for tape rolls and end cutting system.
(d)
Trimming unit at 9000 R/min.
(e)
Automatic temperature control by the machine during all the working
process.
(f)
Panel feeder with wide multi-layered belt.
(g)
Front telescopic table extension with rollers.
Specifications:
(a)
Motor Power: 3HP
(b)
Power Source: 3Phase / 220v / 60Hz
(c)
Minimum panel length – 11 in
(d)
Minimum panel width – 3 ½ in
(e)
Minimum edge thickness – 0.4mm
(f)
Maximum edge thickness – 3mm
(g)
Minimum panel thickness – 3/8 in
(h)
Maximum panel thickness – 1 ¾ in
(i)
Minimum Edge width – 7/16 in
(j)
Maximum edge width – 1 7/8 in
