SKETCHNBUILD SNB-12A, Руководство пользователя

Страница: 4 / 27

2
＊
Stand out of the bounce area of saw blade side and workpiece when operating and
do not stand in middle of saw blade.
＊
Remove the loose matters around saw blade before starting the machine.
＊
Cutting shall not be started until the saw blade up to full speed.
＊
Use safety cover forever!
＊
Except cross-cutting long and thin wood into pieces, the riving knife shall be used
forever and the riving knife shall not be thicker than the cut width and thinner than
the main saw blade.
When cross-cutting long and thin wood into pieces cutting, use the anti-bounce device,
such as fix it in the sliding table groove with striker plate against moving. After
cross-cutting long and thin wood into pieces, remount the riving knife and safety
cover immediately.
＊
When narrow wood is cut longitudinally, the feeding parts shall be used.
＊
For the purpose of avoiding the cut wood from being brought upward and
bounced out by the uprising tooth ring, an offsetting wedge may be used for
instance.
＊
Do not cut round log with saw using standard feed auxiliary device or check plate.
＊
Fix the workpiece on the sliding table with striker plate when trimming.
＊
When using feed device, it at lease needs to use the longitudinal knife as the
anti-bounce device.
＊
Worn and torn sliding table strip shall be replaced promptly.
＊
Do not use wobble saw or cutting device.
＊
Wear hearing protection when operating because the noise in work place is more
than 85dB (A).
＊
The saw dust produced in cutting may affect the sight line and be also harmful to
health, so the two dust collector openings of saw shall be connected with the
suction system. When the suction force is not enough, no operation shall be done,
and proper measures must be taken to ensure when the equipment is started, the
suction system also is started.
＊
Only qualified electrician can operate the electrical equipment of the machine.
＊
Clean the equipment periodically, especially the saw bench, sliding table and
check plate, which is an important safety factory, and before operation start, it
must be ensured that the equipment cannot be started without cause.
Ⅳ
. Machine Installation
4.1 Mounting Safety Cover on Riving Knife
For the purpose of keeping the saw blade on the saw bench, we recommended
separated adjustable protective device.
4.1.1 Mounting Safety Cover