SKC 224-PCXR4, Руководство по эксплуатации

Страница: 10 / 14

Form 37712 Rev 1702
Page 10 of 14
www.skcinc.com
Maintenance
Clean the Pump Inlet Filter
The PCXR4 Universal Sample Pump is fi tted with a fi lter/trap inside a clear plastic inlet port housing. This prevents particles from being
drawn into the pump mechanism. Visually check the fi lter to ensure that it does not become clogged. If maintenance is necessary, follow
this procedure:
1. Clean dust and debris from around the fi lter housing.
2. Remove the four screws and the front fi lter housing.
3. Remove the O-ring.
4. Remove and discard the fi lter membrane.
5. Clean the fi lter housing.
6. Insert a new fi lter membrane and the O-ring.* See Replacement Parts.
7. Rea tt ach the front fi lter housing and cross-tighten the four screws.
* Replace with new O-ring only as needed.
Maintain the Battery Pack
For proper maintenance of battery packs, SKC offers chargers (see Accessories) that condition the battery for optimum performance in
6 to 8.5 hours. For optimum charge, ensure pump is not running during charging. Follow charger instructions.
Fully charge packs before use. See Charge the Battery Pack. For more information on SKC pump batteries, visit http://www.skcinc.com/
instructions/1756.pdf.
To comply with intrinsic safety regulations, battery packs should not be charged in hazardous locations.
Ensure proper orientation of charging cable before plugging it into the charging jack. Improper orientation/contact will short-circuit the
battery and voids any warranty.
Short-circuiting the battery pack will render it immediately inoperative.
Replace the Battery Pack
See Install the Battery Pack.
Notes and Cautions
• Use of a repaired or rebuilt battery pack voids any warranty and the UL Listing for intrinsic safety.
• Use only SKC-approved charger and battery pack designed for the Universal Sample Pump to ensure reliable performance. Failure to do so voids
any warranty and UL Listing for intrinsic safety.
• Use of any device other than the approved battery pack to power the pump voids the UL Listing for intrinsic safety and any warranty.
For more information on SKC pump batteries, visit http://www.skcinc.com/instructions/1756.pdf.
Pump Service
Pumps under warranty should be sent to SKC Inc. for servicing. See Limited Warranty and Return Policy.
Close-up of
inlet fi lter housing
Filter membrane
Screw (4)
O-ring
Inlet