Skanti TRP 5000, Инструкция по эксплуатации

Страница: 45 / 112

4. Set CHECK SWITCH to LEVEL and pull the knob while pressing the TUNE
button. Observe Level-reading on meter. Reading should be as near 3
as possible but never above.
5. Set SUPPLY switch to STAND BY and adjust Level by selecting
appropriate tab settings on wafers 1 to 9 (refer to sections 3.14.2
and 3.14.3). Revert to point 3.
3.14.4.2 If resonance is obtained at, or is outside, one of the extreme
positions of the TUNING knob, select another variometer configuration.
3.14.4.3 If resonance cannot be obtained, remove tab on wafer 21 and insert one
or both of the shortening capacitors (wafers 22 and 23), always use the
largest possible capacitance.
3.14.4.4 If on bands A to H resonance still cannot be c>btained, insert the
output capacitor (wafer 24), if necessary in combination with one or
both of the shortening capacitors.
3.14.4.5
If Level-reading is too high, even with none of the capacitors l to 9
connected, insert the coil at wafer 25 on the 8,12 or 16 MHz bands, or
the coil at wafer 24 on the 22 or 25 MHz bands.
3.14.4.6
If flash-over occurs on 22 MHz at contact 25, insert tab in wafer 25.
3.14.5 2182 KHz:
The adjustment is performed as described above for a frequency in the
lower CT band. In order to reduce the range of the TUNING control
proceed as follows:
1. Move tab on wafer 19 to wafer 18 .
2. Place one end of the clip-on lead on the middle of »2182 KHz Fine
Tuning Coil«.
3. With the other end of the clip-on lead, select that winding on the
stator of Variometer »A« or the »2182 kHz Coil«, below, which gives
the highest level reading.
4. Rotate TUNING control to it se enter position and select that winding
on the"2182 kHz Fine Tuning Coil" which gives maximum Level-reading.
3 - 19