Skandika Fitness MULTIBENCH PRO, Инструкция по сборке и руководство пользователя

Страница: 13 / 20

13
GB
Step 3
1. Fasten the back rest support (No.8) to the u-shaped bracket in the middle of the seat bar (No.2).
Match the openings and secure the connection with a M10 x 72 inbus screw (N.33), two diam 10
washers (No.27) and one M10 securing nut (No.37).
2. Fasten the angle support (No.5) to the u-shaped bracket of the seat bar (No.2). Set up the angles
to the desired height and secure the position with the securing pin. (No.11).
3.
Fasten the butterfly arms (No.9) and the two ang
-
les to the rear part of the back rest support (No.8).
Secure both with one diam 10 washer (No.27) each
and with one M10 securing nut (No.37). Screw the
two M18 securing knobs (No.12)in the hole on the
side of the butterfly arms (No.9) and the hole of the
angles. Select the desired angle and fasten with
each knob (No.12).
4. Fasten the seat (No.15) to the seat bar (No.2),
match the openings and secure both with four M6
x 35 hexagonal screws (No.29) and four diam 6
washers (No.25).
Step 4
1. Fasten the short foam roll handle bar (No.4) to the
front axle (No.1). Use the knob (No.23) to fasten
the bar at the desired position. Slide the two foam
rolls (No.18) over the left and right end of the short
foam roll handle bar (No.4).
2. Feed the long foam roll handle bar (No.6) half-
way into the hole at the upper end of the front axle
(No.1). Slide the two foam rolls (No.18) over the
left and right end of the long foam roll handle bar
(No.6).
3.
The assembly is completed.
ASSEMBLY INSTRUCTIONS