12
1.
When cutting multiple sheets of material, the cutting is incomplete.
It may be necessary to use fewer sheets of material with intricate shapes. Add
a Mylar Shim directly below die (see Figure J) to increase cutting pressure on
material. Two Mylar Shims are provided with the Machine. Add one Shim to the
sandwich first, and if die still does not cut through material, use another Shim.
2.
The Sliding Tray appears warped or does not slide smoothly.
Sliding Tray (part #656254) may need to be replaced. Contact Sizzix
Customer Relations for ordering information.
3.
When rolling the “sandwich” through the machine, only the top Cutting or
Crease Pad moves.
Slide the sandwich toward the back of the tray with the first inch of the top
Cutting or Crease Pad overhanging the sandwich, on the side closest the rollers.
Turn the handle, allowing the Cutting or Crease Pad to pass through the rollers
first, acting as a wedge so the rest of the sandwich can pass through.
4.
When using Crease-Rule dies, the crease rule cuts through the material
rather than creasing the material.
Use of Premium Crease Pad is required with Crease-Rule Dies. For easier cutting,
place the die and material to be cut on the Sliding Tray diagonally (as die size
allows) and then turn the Crank Handle to move the die through the rollers.
5.
Rubber does not eject all parts of the cut material.
Use the Die Pick to remove excess material after each use.
7
. Troubleshooting Solutions
Keeping Dies Clean
It is important to use the Die Pick (included with the Big Shot Pro) to clean out the
bits of paper and other materials that build up in the joints of the dies (where the
cutting rule meets). If dies are not kept clean, the scraps will eventually push the
rule slightly apart.
Cleaning Your Machine
Over time and due to normal use, the machine will become dirty or dusty. This will
happen primarily in the Storage Well underneath the Sliding Tray. To clean, use only
isopropyl alcohol (rubbing alcohol) poured onto a clean paper towel and rub over
Storage Well until it evaporates. With another clean dry paper towel, wipe off any
residue. NEVER use bleach or abrasive cleaners on the machine. The machine DOES
NOT need to be oiled or lubricated.
