E
AST
C
HINA
S
HIPBUILDING
I
NSTITUTE
F
ACTORY
18
SIYANG
四洋
R
6.6 TIGHTENING SEQUENCES FOR CYLINDER HEAD BOLTS.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
6.7 CHECK OF LUBRICATION OIL LEVEL
The lubrication oil level should always be checked before starting.
The level should never be allowed to fall be lower mark.
6.8 LUBRICATION OIL CHANGE
The oil change should be down when the engine is warm.
Run the engine after oil change and check for any leaks.
Stop the engine, allow the oil to settle and top up if necessary.
6.9 ALTERNATOR BELT TENSION.
It is important that the belt tension is checked after an overhaul or
when new belt is installed.
New belt tension:
A force of 3~3.5 kg to deflect belt 3.5 mm
Checking and adjustment at service intervals:
A force of 2~2.4 kg to deflect belt 3.5 mm
6.10 GEARBOX OIL CHECK
Check the oil level.
Fill up if the oil level is below the mark.
SCG-025/ZF12M Gearbox sump capacity : 0.75 liters/0.56 liters.
6.11 PRIMING THE FUEL SYSTEM
The fuel system has to be primed before initial starting, after fuel filter
change, if the fuel system has been disconnected , or if the engine has run
out of fuel and stops.
1.Loosen the vent plug on top of the fuel pump.
2.Turn on the handle of the fuel feed pump
3.Start the handle up-and-down movement.
