
14
Seal the thread with Teflon tape before
installation.
(Fig. 1).
When tightening the sensor, use only use the
316S.S. hexagon fitting to achieve a seal, do not
twist with the body of the sensor.
The transmitter should not be dropped or suffer
any impact or fall, as this can damage the
electronics or the sensor (Fig.3).
Electrical connection with DIN connector:
Figure 4. Shows the steps for proper assembly of
the connector. When you tighten the threaded
part, stop once you feel that the rubber seal is at its
maximum compression point. Do not over-tighten
the thread. It is very important that the connector is
securely sealed so that the class protection is
maintained and no infiltration occurs.
Do not turn or handle by the housing
(Fig. 2).
Do not insert any object into the entry point of the
transmitter supply. This will immediately damage
the membrane.
Fig. 1
Fig. 2
Fig. 3
Handling
Rubber seal connection
Screw
Screw O’ring
Cable seal
Cable gland
Enclosure
Fig.4
Cable
Cable
Vent tube
Vent tube