sitrex DM/4, Список запасных частей и сборка, использование и обслуживание

Страница: 39 / 50

INSTRUCTION FOR INSTALLATION
,QVWUXFWLRQVIRULQVWDOODWLRQ
+RZWRDGDSWWRWKHWUDFWRU
The machine can be adapted to tractors with various gauges by placing the two hoist arms as
shown in fig.9, so that height A is about 10 cm (4 inches) when the machine is in the work
position (see 7.1):
The hoist pins of the machine with 4-5 disks (fig.2) are different from those of the machine with 6-
7 disks (fig.7).
The pins for the machine with 4-5 disks are suitable for 1st and 2nd class couplings (22mm/0.86
inches and 28mm/1.1 inches) whereas the pins for the machine with 6-7 disks can be used only
with a 2nd class coupling.
In order to obtain the various positions shown in fig.9 proceed as follows:
a) with 4-5 disks turn the pin that is not holding the safety hook in place correctly upside down
and remove or insert adjuster bush 5 into the other pin.
b) with 6-7 disks turn the pins upside down in the respective slots and fasten into position with
screws 6 and 9 (fig. 7) in one of the adjustment holes on the lateral projecting part of the pin.
The third point has to be adjusted so that axle E in fig. 14 is vertical.
1) Start up the hydraulic hoist and raise the drawbar slightly.
2) Adjust and stabilise the lower hoist arms of the tractor on each side.
3) If necessary, move the vertical movement adjuster tie rod on the hoist arms until both ball-
and-socket joints are at the same height above ground.
4) Use peg 3 to fasten the rest feet (fig. 10) in position 1.
5) Connect hoist chain 2 in figure 14 to the tractor for the time being.
+RZWRDGDSWWKHFDUGDQVKDIW
In order to make sure that the cardan shaft is the right length compared with the tractor power