Document NO.
：
RD-558A-39-001
5
/
5
Version: F
Installation:
·
Fix the two AA batteries to each battery box of the smoke
alarm.
·
According to the
“
Wireless function
description”
Section to operate the smoke alarm. Ensure the wireless
function is ok.
·
Then press the bracket on the installation position, mark
installation hole of bracket with pencil.
·
Bore two installation hole on the sign with electric drill. Make
diameter of holes is 5mm, Strike the two plastic plugs into
holes with hammer.
·
Attach the bracket to the plastic plugs and fix tightly the screws
(3*25mm) into the plastic plugs. (refer to Diagram 3).
·
Fit the alarm on the bracket and turn the alarm body clockwise,
until matching well on the bracket.
·
Test smoke alarm using test button. The alarm will sound 3
short beeps
–
1.5 seconds pause, then repeat it until release the
button.
·
if no sound, it indicates a defective alarm, you can refer to
“Trouble shooting” for solution or return to your retai
ler
during warranty.
·
If you have any questions on installation, you can contact your
retailer.
·
During testing, may the other smoke detector will alarm. Once
release the button, others will stop alarming in 1 minute. In
such a way, you can check the wireless function.
WARNING:
To prevent injury, this unit must be securely attached to the
ceiling in accordance with the installation instructions.
Manufacturer:
SITERWELL ELECTRONICS CO., Limited
ADDRESS:
No.666 Qingfeng Road, Jiangbei District, Ningbo,
Zhejiang Province, China
TEL: 0086-574-87729581
FAX: 0086-574-87729581
E-Mail: [email protected]
http://www.china-siter.com
