Document NO.:RD-517-39-001
Version: B 2017.02.14
- 7 -
Wire on alarm harness connected to:
Black wire --- Hot wire of AC line
White wire --- Neutral wire of AC line
Yellow wire --- I/O signal as interconnect line of other
Units in the multiple station set up.
Mounting Instructions:
After selecting the proper location for your smoke alarm,
wire the AC QUICK CONNECTOR harness as described
in the Wiring instructions (AC power should be turned off
at this stage).
Turn the alarm body counterclockwise and seperate the
bracket.
Remove locking plug from the bracket with screw driver
(refer to Diagram 9).
Hold the bracket in the installation position, mark
installation holes of the bracket with a pencil.
Bore two installation holes in the marked positions with a
3/16 (5 mm) drill bit. Press the two plastic plugs into
holes with hammer. (Refer to Diagram 10)
Diagram 10
Pull the AC QUICK CONNECTOR through the center
hole in the bracket. Attach the bracket to the plastic plugs
and tighten the screws into the plastic plugs (refer to
Diagram 11 - installation sketch map).
Installation sketch map:
Diagram 11
Install the battery into battery box.
Connect the AC QUICK CONNECTOR to the alarm
body.
Fit the alarm on the bracket and turn the alarm body
clockwise, until it aligns with the bracket.
Insert locking plug into the gap between bracket and
bottom cover to lock the alarm in place (Refer to Diagram
12).
locking plug
Diagram 9
Do not tear labeling
Holes of ceiling
Plastic plugs
Terminal
Bracket
Screws
AC quick connector
