- 26 -
ERROR CORRECTION
During sewing, LED show out “ ” and stop. Turn
hand wheel to solve torque problem.
START TO SEWING (PREPARATION)
After has been familiar with sewing machine each regulator and the appendix function, and then may start sewing.
The following several points which are before stitch should pay attention, so it may cause sewing to be smoothly.
1. Inspects the needle to have straight, incisively and correctly installs.
2. Before start sewing and after completes sewing, raise the needle to the top.
3. Before sewing, first gently pull on the upper and down threads about approx 10 centimeters
(4 inches.) and pull both threads pass through under the presser foot.
4. Try to sewing on the some rags, to decide the suitable stitch length and the thread tension.
5. The seam cloth puts underneath presser foot.
6. Use foot speed controller. Slowly depress the foot controller to sewing.
7. Each suture line start and the ending must reverse sew a short distance to prevents off-line. (But reverse
sewing is only suitable in straight stitch)
8. Gently guide by the hand in front of the needle to deliver the cloth, do not hold on the cloth, otherwise can
affect sewing machine itself to deliver the cloth.
9. When turn the hand wheel, turn to front (counter-clockwise).
10. To avoid the sewing machine needle pulling curving or breaks off, after sew completes, before move away the
cloth, the needle-tip certainly must leave the cloth, rises to the top, and then move cloth by the needle back.
11. Separate the machine from the power system if you leave it unsupervised.
12. When turn on the machine and press the foot controller, the stepping motor & zigzag width motor will
functioning for “Neutralization the mechanism”, there will be some noise occurred, that’s a normal functioning
sound, don’t worry about such sound. After such “neutralizing” function, then you can start to enjoy the sewing.
