Siruba 700KS-LFD6-K1, Инструкция, Страница: 20 / 48

控制盒面板說明
THE ILLUSTRATION OF
THE CONTROL PANEL
1.
車縫模式指示燈：指示燈
ON
表示車縫模式；
指示燈
OFF
表示設定模式。
2.
準備鍵：可用於轉換車縫模式或設定模式。
3.
工程段數：可設定
1~18
工程段數。
4.
送料長度：設定每針送料長度，設定
5~65
。
(5
表示
0.5mm
；
65
表示
6.5mm)
5.
針數設定：設定每一段工程的所需的針數，
設定值
0~999
針。
6.
循環設定：可儲存
10
組循環縫製設定
(A~J)
。
7.
針數計數：計數已車縫完成的針數值。
8.
電源指示燈：顯示綠色指示燈表示可正常
車縫；顯示橘色燈表示有故障需排除；指
示燈
OFF
時，請確認電源開關是否開啟。
9.
取消鍵：可設定循環結束；可取消循環結
束；可載入原設定值。
1. Sewing mode indicator light: When the
indicator light is ON, it indicates the
sewing mode; when the indicator light
is OFF, it indicates the setting mode.
2. Preparation key: It is used to switch
between the sewing mode and the
setting mode.
3. Section: Set sections 1~18.
4. Feeding length: Set the feeding length
for each stitch. The setting values are
5~65. (5 indicates 0.5mm;65 indicates
6.5mm)
5. Stitch setting: Set the number of
stitches that is required for each
section. The setting values are 0~999
stitches.
6. Circulation setting: It can memorize
10 sets of setting values of circulatory
Sewing (A~J).
7. Stitch count: It counts the number of
stitches that is completed.
8. Power light: When the light is green, it
indicates the normal sewing. When the
light is orange, it indicates that there is
a glitch which has to be eliminated.
When the light is OFF, check if the
switch is turned on.
9. Cancel key: It can end the circulation
setting; it can end the circulation
cancelling; it can load the original
setting value.
1 2 3 4 5 6 7
15 14 13 12 11 10 9
8
16
17
18
P17