Siruba 700KS-LFD6-K1, Инструкция, Страница: 19 / 48

4.Adjust the position of blowing hole.
Adjust the feeding roller for aligning the red
line to the center of the elastic belt. (The
blowing hole of the feeding tape is under the
red line.)(As the diagram A) Be aware that
there are two red lines. For using the elastic
belt less than 1 inch, have it align to the
right red line (As the diagram B); for using
the elastic belt over 1 inch, have it align to
the left red line. (As the diagram C)
4.
吹氣孔位置調整
調整送帶滾輪的左右方向
(
方法見前述及圖
六
)
，使紅線對準鬆緊帶中央
(
送帶用吹氣
孔在紅線的下方
) (
如圖
A)
。須注意，長輪
有兩條紅線，使用
1
英寸以下鬆緊帶時，使
右邊紅線對準鬆緊帶中央
(
如圖
B)
；使用
1
英寸以上鬆緊帶時，使左邊紅線對準鬆緊帶
中央即可。
(
如圖
C)
圖
A.(
短輪
)
Diagram A. (Short Roller)
紅線
Red Line
紅線
Red Line
紅線
Red Line
送帶吹氣孔
Feeding
Blowing Hole
送帶吹氣孔
Feeding Blowing Hole
送帶吹氣孔
Feeding
Blowing Hole
圖
B.(
長輪
)(
帶寬
1
英寸以下示意圖
)
Diagram B. (Long Roller)
(The diagram of the belt less than 1 inch)
圖
C.(
長輪
)(
帶寬
1
英寸以上示意圖
)
Diagram C. (Long Roller)
(The diagram of the belt over 1 inch)
鬆緊帶
Elastic Belt
鬆緊帶
Elastic Belt
鬆緊帶
Elastic Belt
P16
Introduction