10
(c) Re-assemble in the reverse order.
10.2 TO REMOVE THE PILOT
BURNER ASSEMBLY
(a) Follow 10.1 above to remove the
burner tray.
(b) Disconnect the thermocouple
connection from the back of the gas
valve.
(c) Disconnect the 4mm pilot burner tube
from the pilot burner assembly.
(d) Disconnect the electrode lead from the
pilot burner assembly.
(e) Remove the two screws at the front of
the pilot burner bracket
(f) If defective, the whole assembly
MUST
be replaced.
DO NOT
attempt
to replace the individual components
as this could compromise the
operation of the ODS pilot.
(g) Reassemble in the reverse order.
10.3 TO REMOVE THE GAS TAP /
FSD / IGNITION UNIT
(a) Follow 10.1 above to remove the
burner tray.
(b) Disconnect the thermocouple from the
tap.
(c) Disconnect the 4mm pilot burner tube
from the tap.
(d) Disconnect the 8mm burner supply
tube from the tap
(e) Disconnect the 8mm gas inlet tube
from the tap.
(f) Pull off the control knob.
(g) Remove the retaining nut from the
front of the control panel. The tap /
FSD / ignition unit can now be
removed and exchanged.
(h) Re-assemble in the reverse order.
11
MAINTENANCE SPARES
During servicing and maintenance your appliance may need some replacement parts. Here
is a short list of spare parts that are available:
Supplier Ref.
Description
Manufacturers Part No.
Coals Kit
NA
Pebbles Kit
CER-PB-ROY-1-SI-3-Z
Logs Kit
CER-LG-ROY-1-SI-4-Z
Granule Kit
CER-GR-ROY-1-DA-3-Z
Remote control valve
VAL-RC-ROY-1-SO-2-A
Remote Control hand set
VAL-RC-ROY-1-SO-3-A
Remote control box
VAL-RC-ROY-1-SO-4-A
Remote control pilot assembly
VAL-RC-ROY-1-SO-5-A
Remote control receiver
VAL-RC-ROY-1-SO-6-A
Manual valve
VAL-CV-ROY-1-SG--A
Please contact SIROCCO if other parts are required.
12
FAULT FINDING
FAULT
CAUSE / POSSIBLE REMEDY
Pilot will not light.
See Ignition Functional Check 1.
V-11-07