Sirius Satellite Radio SM923 52, Инструкция по установке, использованию и обслуживанию

Страница: 14 / 16

14
Replace the led lamp SM923 - SM924
Before to replace the led lamp switch off the ap-
pliance then by using appropriate tools remove
the led lamp from its slot (Pic. 9).
Take out the led lamp from its connector and re-
place with similar characteristics.
To find the correct led lamp please check on the
replacement part list.
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a simi-
larly qualified person in order to avoid a hazard.
To replace the LED bar SM927
Remove the grease filter and put pressure on the
led bar placed in the internal part of the built-in
hood until you can unhook the springs, then di
sconnect the connector and replace the bar with
a similar one (Pic. 14)
- An accurate maintenance guarantees good fun-
ctioning and long-lasting performance.
- Particular care is due to the grease filter. It can
be removed by pushing its special handle toward
the back-side of the cooker hood and turning the
filter downwards so to unfasten it from its slot
(Pic. 3).
To insert the filter just perform the opposite ope-
ration.
The grease filter needs cleaning by regular hand-
washing or in dishwashers every two months at
least or depending on its use.
In the filtering version, it is necessary to repla-
ce the carbon filter (Pic.7 - SM923 / Pic.12-13 -
SM924 -SM927) periodically.
The carbon filter can be removed by first remo-
ving the grease filter (picture 3) and then pulling
the appropriate plastic tab of the carbon filter by
releasing it from its seat (Pic.7 - SM923 / Pic.12-
13 - SM924 -SM927). The carbon filter is installed
in the reverse operation. The replacement of the
carbon filter takes place in relation to its use, at
least once every six months.
- To clean the appliance itself tepid water and
neutral detergent are recommended, while abra-
sive products should be avoided. For steel ap-
pliances specialized detergents are recommen-
ded (please follow the instructions indicated o the
product itself to obtain the desired results).
- Warning! To take down the appliance from the
cabinet, remove the definitive fixing screws (Pic.6
SM923 - Pic. 11 SM924 - SM927) using a screw-
driver, get off the grease filters (Pic. 3).
Act on the small handle of the springs, which are
inside the built-in unit, with the necessary streng-
th to unhook the appliance from the cabinet.
* If the supply cord is damaged, it must be re-
placed by the manufacturer or its sevice agent
or a similarly qualified person in order to avoid
a hazard.
MAINTENANCE