Sirius Satellite Radio SL926DLTM Series, Руководство по установке

Страница: 7 / 20

7
SL926 DL
Working:
6 channel control for rangehood remote.
• When the rangehood is first turned on, hold the
lighting button for 5 seconds.
TECHNICAL DATA
• Alkaline battery powered: 12 V mod. 23 A
• Operating frequency: 433.92 Mhz
• Combinations: 32.768
• Max. consumption: 25 mA
• Operating temperature: -20 ÷ + 55 °C
• Dimensions: 120 x 45 x 15 mm.
OPERATING THE REMOTE
The transmitter is equipped with 5 buttons as
specified below:
: Light ON/OFF.
: Motor ON (speed level 1) / OFF.
: Reduce speed.
: Increase speed.
: 10-minute shut-off timer.
DEFAULT OPERATING CONDITION
The manufacturer supplies the remote control unit
ready to be used with codes preset in the factory.
REMOTE CONTROL OPERATION MODE
Standard configuration:
Standard configuration requires all rangehood remote
control systems to be provided with the same
transmission code. In the event two rangehoods are
installed in the same room or nearby, each system
may affect the operation of the another. Therefore,
the code of one remote control system must be
changed.
Generating a new transmission code:
The system is provided with preset codes. Should
new codes be required, proceed as follows: Press
simultaneously buttons:
for two seconds. When LEDs are on, press buttons:
(within 5 seconds). The LEDs flash 3 times to indicate
the procedure is completed.
WARNING! This operation deletes permanently
the preset codes.
Learning the new transmission code.
Once the transmission code is changed in the
remote control unit, the electronic central unit of the
rangehood must be made to set the new code in the
following way:
Press the red main power-off button of the hood
and then restore power to the electronic control unit.
Within the next 15 seconds, press the Light Button
to synchronise the central unit with the code.
Reset of the Factory configuration:
To restore the Factory configuration, follow the
procedure described below: press simultaneously
buttons:
for 2 seconds. When LEDs light on, press buttons:
(within 5 seconds). LEDs flash 6 times to indicate the
procedure is completed.
WARNING! This operation deletes permanently
the preset codes.
Emergency button:
In the event that the remote control does not work,
use the emergency button to switch the appliance
off. After any necessary repairs have been performed,
reset the emergency button.