6
SIR-PAN1 Installation Guide
Installation
It is recommended that prior to starting
the installation, you thoroughly read
this manual and follow the guidelines
listed below:
Consider the mounting location
carefully. You should make sure that
you avoid the following:
• Any location where the tuner is
exposed to moisture.
• Any location where the unit is
exposed to extreme heat.
• Any location that would interfere
with moving parts on the vehicle or
hamper driving.
Mounting the SIR-PAN1 Tuner
Be sure that you find a location that is
flat and has clearance above the unit to
prevent any damage as well as allow
for ventilation.
Do not install the tuner under the
carpet or in a small enclosed area
without proper ventilation. Doing so
can result in damage to the tuner or
the vehicle.
Use the supplied screws to securely
fasten the unit.
Caution:
If you are attaching the unit directly to
the vehicle’s chassis, be sure that you
check to make sure the area behind the
unit is free from moving parts, fuel or
break lines, wire harnesses or any
other items which may get damaged by
drilling a mounting hole or using the
supplied screws.
Installing the Antenna
The antenna includes a 6-1/2” cable
cover/tail which covers the exposed
antenna cable and keeps it attached
securely to vehicle roof. The tail also
helps position the antenna the proper
distance from the window, sunroof or
rear hatch.
To attach the cover/tail:
1. Once you have determined the
proper mounting location (see next
section), clean the area with the
supplied alcohol swab.
2. Connect the cover/tail to the
antenna cable, making sure that the
strain-relief on the antenna seats
into the cover/tail groove. Route the
cable through the wire channel in
the cover/tail.
PANASONIC COMP
ATIBLE
SIRIUS SA
TELLITE RADIO TUNER
SIR
-P
AN
1
Antenna
(Underside)
Cable Cover/Tail
Connect the cable cover/
tail to the antenna cable,
insert the cable through
the grove. Peel off the
adhesive tape
3. Remove the remaining protective
tape from the adhesive, carefully
position the antenna with cover/tail
and apply pressure to secure to the
vehicle.
Adhesive Strips
