Italy 100 cutter
Use and Maintenance Manual Ver. 1.1
18
5.3
A
SSEMBLING THE MACHINE
The machine must be installed by qualified staff who have carefully read and
understood the information contained in this manual. In case of doubt, consult
the manufacturer. The user is responsible for ensuring that the installation
complies with the relative regulations in force.
5.3.1 Material provided
The following tools are provided with the machine, which are useful for machine
adjustments and disc replacement:
1)
19mm socket wrench
2)
10mm/13mm monkey spanner
3)
5mm Allen wrench
A tank plug is also provided
5.3.2 Fitting the legs
The machine is supported on four square tubular legs. Two operators are required to
assemble them on the machine body. One at a time, fit the four legs in the respective
housings on the four corners of the tank as shown in the figure. Then, when the upper
through hole of the leg is in correspondence to the upper part of the oblique slit in the
leg, fit the pin and the upper nut. Then fit the second pin and the relative knob and
tighten everything so that you have the configuration shown in the enlargement in the
figure. If the machine is supplied with 2 legs equipped with castors, these must be fitted
on the side opposite to where the operator stands.
