5. Close the housing
a)
Slide the housing outer body along the
internal rail. The internal rail is to be inserted
in the guide fissure as shown in the picture.
b)
Check the proper position of the seal in its
groove on the rear flange.
c)
Tighten the cable glands up till an 8 Nm
torque ratio.
d)
Tighten the two M6 on the rear flange screws
to the main body.
e)
Fix the screw at the bottom of the external
rail to the nut welded on the housing.
1.5
Dimensions
Dimensions in millimetres – Tolerances according QMS – Design and product specifications subject to
change without notice. Dimensions in brackets: N/A.
SA Fixed Series - Installation manual
7
