Siqura HSD620PRH, Руководство по установке, Страница: 17 / 42

Dome Setup and Cable Connection
Page 13
Step 2: Accessing the unit
Using a standard web browser you can now log on to the Siqura HSD620PRH and HSD621PRH's
internal web server.
Step 3: Changing the unit's network settings
The Network web page enables you to make the unit's network addressing compatible with the
network it will be hooked into. You can set a fixed IP address or have the IP address assigned by
a DHCP server. In the latter case, open the Advanced Settings and enable DHCP. Do not forget
to save and reboot the unit after changing the settings.
4.5 System Compatibility
To ensure system compatibility, download the latest firmware from Support > Software on the
Siqura web site at http://www.siqura.com/. Registration is required.
4.6 Dome Cable Definition and Requirements
For operation, the Siqura HSD620PRH and HSD621PRH cameras require either an Ethernet cable
or an appropriate fiber optic cable to carry the signals to a remote viewing site and a cable to
power the dome.
4.6.1 Cable Requirements
For operation, the camera requires a video and cable harness, as described below.

A cable to provide a 24 VAC power supply to the dome.

A Cat-5 Ethernet cable.

Optional cable for alarms.
Important:
Ensure the power supply corresponds with the dome's power requirement, or damage
will occur. If any mistake happens, contact a qualified technician.
4.6.2 Verifying Ethernet connectivity
Refer to the following figure to determine whether you have established an Ethernet connection.
Ethernet socket LEDs green/yellow
Green on/off : 100/10 Mbit
Yellow on/blink
Yellow off/flash