Siqura HSD620PRH, Руководство по установке, Страница: 14 / 42

Siqura HSD620PRH/621PRH
Page 10
Removing the bracket Replacing the bracket
4.2 Switch Definition
It is necessary that the dome ID and communication protocol remain in the default modes when
connecting the Siqura HSD620PRH and HSD621PRH cameras to other devices. The switches
used for configuring these settings are located on the bottom of the dome camera. These
settings are preset to operate the camera with the IP hardware. Changing the settings may make
the camera inoperative using the IP connection.
Refer to the figure and table below for switch location and definitions.
Siqura HSD620PRH and HSD621PRH switches
Switch Definition
A Communication switch
B ISP connector (for firmware upgrades)
C RJ-45/SFP connector
D SD card slot
E Reset buttons
F 22-pin connector
Note:
Switch E has two buttons. Only the button closest to the 22-pin connector is used to
restore factory server defaults. The other button is reserved.