12
OPERATING INSTRUCTIONS….cont
Supplied with the motorcycle jack are two ratchet straps (1” wide x 15ft long), to use
the ratchet straps follow the steps below
Securing a vehicle with the ratchet straps:
Place the ratchet lever in the closed position (Fig.6)
Put the other end of the strap through the spindle centre, then loop it back over
the spindle (Fig.7).
Slightly tighten the strap by ratcheting the ratchet lever back and forth for about
5 or 6 times.
Place one hook on the hook support of the frame and pass the strap over the
vehicle. Hook onto the opposite hook support.
Fully tighten the strap by ratcheting the ratchet lever back and forth until it is
tight.
When the strap is tight lock the ratchet by pushing the ratchet lever down so it is
in the closed position.
Repeat above steps for the other ratchet strap.
Closed position
Ratchet lever
Release latch
Spindle centre
Fig.6
Fig.7
Note:
Do not use pliers or similar to operate the ratchet lever, this could
possibly damage the ratchet mechanism and void any warranty you may
have.
Releasing the ratchet straps:
Hold the ratchet in one hand and with the other hand pull back on the release
latch.
Whilst still holding the release latch, open the ratchet lever fully so it passes the
locking gears and releases the load.
To completely remove the strap, pull up on the ratchet and slide the strap out.
9
GETTING TO KNOW YOUR MOTORCYCLE JACK
Ref. No.
Description
Ref. No.
Description
1.
Height Lock Release Bar
7.
Release Pedal
2.
Handle
8.
Height Lock Bar
3.
Foot Pedal
9.
Hook support
4.
Hydraulic Ram
10.
Lifting Saddle
5.
Locking Screw
11.
Retaining clip (Height Lock Release Bar)
6.
Castor Lock
1
2
3
4
5
5
6
6
7
8
9
9
10
11
