14
OPERATING INSTRUCTIONS….cont
Caution:
Take care when lowering the jack that nothing can get trapped
in the moving parts of the jack, or under the vehicle.
1. Lower the lifting saddle to its lowest position.
2. Place the jack on its side.
3. With a cross headed screwdriver, unscrew
the oil fill screw fully from the hydraulic unit.
4. Fill with SAE 5W hydraulic oil until it reaches
the bottom of the threads.
5. Refit the oil fill screw.
ADDING OIL
Note:
Do not touch either the foot pedal or the release pedal when filling
with oil.
Oil fill screw
Hydraulic ram
1.
Pump the foot pedal so that both height lock bars clear both ridges on either
side of the frame.
2.
Pull back on the height lock release bar and push into the retaining clip to se-
cure it.
3.
Press down gently on the release pedal until it reaches the lowest position.
4.
Remove both ratchet straps.
5.
The vehicle can now be removed.
OIL CHANGE
For the best performance and longest life, completely change the oil at least once
per year. Always dispose of hydraulic oil in accordance with local regulations.
MAINTENANCE
7
CONTENTS & ACCESSORIES
This SIP motorcycle jack is covered by a 12 month parts and labour warranty covering
failure due to manufacturers defects. This does not cover failure due to misuse or op-
erating the vehicle jack outside the scope of this manual - any claims deemed to be
outside the scope of the warranty may be subject to charges Including, but not lim-
ited to parts, labour and carriage costs.
This guarantee does not cover consumables such as rubber pads and oil etc.
In the unlikely event of warranty claims, contact your distributor as soon as possible.
GUARANTEE
Note:
Proof of purchase will be required before any warranty can be hon-
oured.
Description
Qty.
Description
Qty.
680Kg Vehicle Jack
1
Instruction Manual
1
Hydraulic Ram
1
Bolt (M8 x 12)
1
Handle
1
Bolt (M8 x 25)
2
Foot Pedal
1
M8 Nut
2
Height Lock Release Bar
1
M8 Spring Washer
4
Ratchet Straps
2
Handle Pin
1
