14
ASSEMBLY INSTRUCTIONS….cont
Once the side extensions and the leg set are loosely fitted; Turn the saw over onto
a firm level surface.
Ensure that the main saw table is as level as possible.
With a straight edge, or similar, set the extension tables level with the main saw bed
and proceed to tighten all of the nuts and bolts etc.
SETTING THE RIVING KNIFE
The riving knife (6) is a safety device that sits behind, and moves relative to the saw
blade to, when set correctly, help eliminate kickback. To set the riving knife:
Set the saw blade (3) to the max. cutting depth, bring it to the 0° position and lock
it (see operating instructions).
Loosen and remove the screw (23) from the table insert (2) using a Phillips screw-
driver, and remove the table insert.
The distance between the saw blade (3) and the riving knife (6) must be between
3mm & 5mm (Fig. 9).
Loosen the mounting bolt (24) in order to adjust the riving knife (6) until the right dis-
tance is achieved.
Retighten the mounting screw (24) and refit and secure the table insert (2).
Slot
15
Note:
Do not over tighten the wing-nut; the guard should move freely and
drop over the blade under its own weight.
ASSEMBLY INSTRUCTIONS….cont
FITTING THE BLADE GUARD
Loosely fit the bolt (25) & wing-nut to the blade guard (4).
Slide the bolt (25) into the slot on the riving knife (6) and push back (Fig.10 & 11).
Tighten the wing-nut to hold in place.
Push one end of the suction hose (5) onto the suction adapter (26) and the oppo-
site end to the connecting piece of the blade guard (4) (Fig.12).
