18
OPERATING INSTRUCTIONS….cont
Insert the mitre gauge (7) into the slot (31) of the saw table (Fig.17).
Loosen locking knob (32).
Turn the mitre gauge (7) until the arrow points to the angle required.
Re-tighten locking knob (32).
When cutting larger workpieces, the mitre gauge (7) can be lengthened with the aux-
iliary extrusion (34) (Fig. 17).
USING THE MITRE GAUGE
Caution:
Do not allow the auxiliary extrusion to come into contact with the
saw blade; The distance between the extrusion and the saw blade should
be at least 2 cm.
Slacken the thumb screws (28) and push the extrusion (27) forward until it touches
the imaginary 45° line.
Re-tighten the wing nuts (28).
Once set in the correct position and orientation, ensure that the rip-fence is locked in
position by pressing down on the locking handle (30).
11
GETTING TO KNOW YOUR SAW
Ref. No.
Description
Ref. No.
Description
1.
Main Table
9.
Push Stick
2.
Table Insert
10.
Saw Stand
3.
Blade
11.
On/Off (NVR) Switch
4.
Blade Guard
12.
Height/Angle Adjust Hand Wheel
5.
Extraction Hose
13.
Angle Lock
6.
Riving Knife
14.
Rip Fence Guide Rail
7.
Mitre Gauge
15.
Rip Fence
8.
Table Extension
