6
GUARANTEE
This SIP Saw Horse is covered by a 12 month parts and labour warranty covering failure
due to manufacturers defects. This does not cover failure due to misuse or operating
the fan outside the scope of this manual - any claims deemed to be outside the
scope of the warranty may be subject to charges Including, but not limited to parts,
labour and carriage costs.
In the unlikely event of warranty claims, contact your distributor as soon as possible.
Proof of purchase will be required before any warranty can be honoured.
Note:
Proof of purchase will be required before any warranty can be hon-
oured.
CONTENTS & ACCESSORIES
O
L
M
N
R
Q
P
11
1. Slide the pivot clamp support (P) into the main leg (F), either to the left or right hand
side of the stand depending upon the operators preferred choice (Fig 1).
2. Bolt the measuring rod support (O) onto the pivot clamp support using the supplied
bolt (M8x20) (Fig 2).
3. Remove the cap from the long end of the measuring rod (R) and slide it through
the measuring rod support (O); use the eye bolt (M10x20) to secure (Fig. 3).
4. Slide the pivot clamp onto the pivot clamp support, and use the R-Clip to secure it
Note:
Take care not to over-tighten the nuts/bolts to reduce the risk of
damaging the tubing. The nuts / bolts need to be just tight enough to en-
sure that the stand is sturdy and secure.
FITTING THE CHAINSAW HOLDER
Note:
When using a chainsaw (not supplied) with this saw horse, it is vital
that all safety precautions are followed by the chainsaw manufacturer, if
in any doubts contact the chainsaw manufacturer for more information.
ASSEMBLY INSTRUCTIONS….cont
B
L
L
B
B
L
B
L
E
E
E
E
9. Lastly fit the feet (L) to the bot-
tom of the stand, using bolts
(B) and nuts (E).
Note:
Do not over-tighten the nut/
bolt as there should be some
movement to allow the feet to piv-
ot.
