SIP 01552, Руководство пользователя

Страница: 12 / 18

12
THICKNESSING
-Set the desired height with handle assembly at spindle A with reference to scale.
Depth of cut: 3mm = 1turn of the wheel
-Slide in narrow wood in the middle.
Timber feed device: the timber is feed automatically by two rollers (mounted on spring), one of which is
fluted and one of which is smooth. Engage the wood face against the thickness-working table, until the
feed roller catches it. Allow the work piece to pass without pushing. Plane the wood so that the thickness is
constant on its whole length.
Long work piece should be supported both at entry into and exit from the machine, in order to avoid hells
at the end of the timber. A heel of 1/10 mm is acceptable.
Before beginning machining, check that the timber to be used is free from knots, in order to avoid
dangerous breakages. If several pieces are to be machined consecutively, all pieces of the same
thickness should be passed through one after another without changing the setting. Perform the
machining cycle from the beginning until the required thickness is obtained.
Pass each piece one after another (when the feed roller is free) and allow them to pass through without
pushing (as soon as they are caught by the feed roller).
REPLACING BLADES
Disconnect machine from power before servicing!
Replacing blades
-Unplug the jointer/planer from power source and turn the switch to “off” position.
-Block the blade guard from closing down.
-Loosen and remove three blade lock screws securing blade and blade
clamp.
-Lift blade and blade clamp from cutter head.
-Clean any sawdust and resin buildup from cutter head and blade clamp.
-Place blade clamp against the replacement blade and replace in cutter head.
-Secure blade and blade clamp using three blade lock screws. Do not over-tighten blade lock screws
first.
Note: Check blade height at both of blade
-Tighten blade lock screws.
-Recheck blade adjustment and make sure blade is still level with out feed table.
-Repeat the procedure to replace the other blade.
-Remove the scrap wood and release blade guard.
-Make sure all the blade lock screws are tight and snug.
NOTE:
-The blades, which are used with the tool, may be replaced or re-sharpened.
-If the blades are re-sharpened, the re-sharpening should be not more than 3 times with 0.05mm max.
each time.
-The blades used in this tool cannot be used to rebate
.