SINGFLO 2440 Series, Руководство пользователя

Страница: 4 / 18

4
f) Insert the wire leads into Plug (Cable Adapter) connectors.
Using a 5/64" Allen Wrench tighten the set screws (Fig. 6).
g
) Slide the Inner Cable Boot (Part B) over the plug until it is flush with
the first step on the collar (Fig. 6).
Wipe the grease from the surface of Inner Cable Boot and cable.
Tape end of Inner Cable Boot tightly to the cable.
Be sure to tape 4 in. (10 cm) below the Inner Cable Boot on the cable.
Note: This taped area allows the Outer Cabl e Boot (Part C) to slide freely over the Inner Cabl e Boot.
DO NOT REMOVE THE TAPE.
h) Lubricate the outer surface of the Inner Cable Boot and tape with supplied O-Ring grease.
Slide the Outer Cable Boot (Part C) over the Inner Cable Boot until it is flush with
the second step on the collar (Fig. 6).
i) Push the Plug (Cable Adapter) into the Receptacle (Cable Adapter) until the collar is seated flush.
NOTE: The ori entation of the Pl ug(Cabl e Adapter) will not effect the pumps performance.
j) Push the Nut (Part D) over the Plug (Cable Adapter) and then finger tighten the nut.
NOTE: Before continuing, operate the pump to check all electrical connections,
using the correct power supply.
Refer to Technical Specifications (Pg. 14).
If pump does not operate Refer to "Helpful Hints" (Page 8) before continuing .
3) Install the 6 in. hose and fitting (1/2" NPT X 1/2" BARB) (Fig. 7, page 5).
a) Press the fitting into the 6 in. hose, slide the clamp on the hose and over the fitting and tighten the clamp securely.
b) Slide another clamp on the 6 in. hose, slide the assembly over the barbed fitting on the pump,
and tighten the clamp securely.
Note: Sel ect the proper adapter hos e and accessori es for the pump.
USE OF DISCHARGE PIPE LARGER THAN 3/4" IS NOT RECOMMENDED..
Use 150 P.S.I. Min. (10 bars) working pressure rated 1/2 in. I.D. (12.7 mm I.D.) smooth bore hose (Part not included.).
Use All-Stainless Steel hose clamp (Part not included.
1 /2 " N PT