When inserting or removing the bobbin, the needle must
be fully raised, to the highest position.
Attention:
-Remove the extension table, then open the hinged cover. (1)
-Pull the bobbin case tab (a) and remove the bobbin case. (2)
-Hold the bobbin case with one hand. Insert the bobbin so
that the thread runs in a clockwise direction (arrow). (3)
-Pull the thread through the slit and under the finger,
(4) Leave a 6 inch tail of thread.
-Hold the bobbin case by the open hinged latch. (5)
-
(6)
Turn power switch to off ("O") before inserting or removing
the bobbin.
while
holding the bobbin down in the case until thread clicks into
place
.
Insert the bobbin case into the shuttle, so that the bobbin
case finger is aligned at 12 o'clock.
Inserting the Bobbin
13
EN
a
Содержание Start 1304
Страница 1: ...Manuel d Instruction Instruction Manual Manual de Instrucciones StartTM...
Страница 2: ......
Страница 70: ......
Страница 71: ......