Singer SDHM-10DI, Инструкция по эксплуатации

Страница: 10 / 52

10
ENGLISH
Air speed set key
Press this button to set the high wind or low wind, wind speed can only be
changed manual in normal mode, can’t be switched in automatic mode. Under
the drying mode is high wind, can’t be switched.
High wind, the indicator light shows orange, low wind the indicator light shows
blue.
Anion
Press this button, the purifying function starts, then the Anion control circuit will
start after 8 seconds (the blue indicator light is on). Then press this button again,
Anion function will close (the blue indicator lights turns off). The control circuit
shuts down immediately.
Mode
Press this button to switch between 3 modes: Auto mode (Default); Common
mode; Continuous (clothes drying) mode.
1. Auto mode (blue light): Auto mode is the default mode when the power is on.
The light is blue and the fan speed is low. Then the fan speed can be changed ac-
cording to the environmental humidity. When the default set humidity is 50%RH,
the compressor starts to work when the environment humidity is higher (+3%) or
equals with the default set humidity.
When the environmental humidity is smaller than the setting humidity (-3%), the
compressor does not work.
When the difference between environmental humidity and the setting humidity is
more than RH10%, the fan works in low wind. Meantime, the fan speed should
be switched under this state.
2. Common mode (purple light)
Press this button to switch to common mode. The purple light is on under this
mode. When switch to this mode, the fan speed will keep the same as last mode
and the compressor will start according to the current environmental humidity
and the setting humidity. It will operate as follows: When the environment humid-
ity is more 3%RH than the setting humidity, the compressor starts to work; when