Chapter 2. Installing and Set Up
2-6
Loading Paper
1.
After confirm Front Cover is closed, push
“
|
” side of Power Switch to turn on the
power of printer.
2
Check the setting.
●In case paper set is first time.
(
Step6
)
●In case paper is replaced, go to next step.
3. Push the button of PAPER REWIND button
①
on control panel.
4. When “Roll Back OK?” is displayed, push
the button of ENTER button
②
.
5. When “Load Paper” is displayed, open the
Front Cover.
6. Hold up the lever to release the lock, and
open Paper Unit.
7. Check the setting.
●In case paper set is first time.
(
Step10
)
●In case paper is replaced, go to next step.
8. Remove used paper for replacement.
9. Remove Paper Flanges from used paper roll.
10. Install Paper Flange(Blue) and Paper
Flange(Black) to new paper roll.
11. The paper is not set correctly if there is a
gap of around 10mm between the paper
flange and paper. Match the notch of the
paper flange and the notch of the paper
core by rotating the paper flange.
Do not remove the seal attached to the paper
until the paper is set in the printer.
12. Set the paper in the printer.
Set the paper by matching the color of the
paper flange and the cover of the holder.
After setting the paper, remove the seal
from the paper.
13. Close the Paper Unit.
①
②
Caution: Paper feed part carefully
so as not to catch your
fingers.
Содержание DP-1045
Страница 10: ...Chapter 1 Important Safety Instruction 1 6 MEMO...
Страница 23: ...Chapter 2 Installing and Set Up 2 13 MEMO...
Страница 31: ...Chapter 4 Routine Maintenance 4 5 MEMO...
Страница 41: ...YTE8 J0507E Revision 2011...