Press "+" and "-" buttons simultaneously to lock or
unlock the keypad. If the remote controller is locked,
Combination of "+" and "-" buttons:
is displayed. In this case, pressing any button,
blinks three times.
about child lock
Function introduction for
combination buttons
At unit OFF, press "Mode" and "-" buttons simultane-
ously to switch between °C and °F.
Combination of "Mode" and "-" buttons:
About switch between Fahrenheit and centigrade
Combination of "Temp" and "Clock" buttons:
About Energy-saving Function
Press "Temp" and "Clock" simultaneously in Cool
mode to start energy-saving function. Nixie tube on
the remote controller displays "SE". Repeat the oper-
ation to quit the function.
Combination of "Temp" and "Clock" buttons:
About 8°C Heating Function
Press "Temp" and "Clock" simultaneously in Heat
mode
to start
8°C
Heating
Function
Nixie
tube
on
the
remote
controller
displays
" "
and
a
selected
temperature
of "8°C"
(46°F
if Fahrenheit
is
adopted).
Repeat the operation to quit the function.
About Health function (COLD PLASMA)
Turn
on
the
unit, start
up
the
fan
(Breezing
and
X-FAN
are
excluded)
and
press
Health
button
on
remote
controller
to
start
health
function
(If there
is
not
Health
button
on
remote
controller, the
unit
defaults health function ON. )
12
●
●
●
●
●
●
Replacement of batteries in
remote controller
During operation, point the remote control signal
sender at the receiving window on indoor unit.
The distance between signal sender and receiving
window should be no more than 8m, and there
should be no obstacles between them.
Signal may be interfered easily in the room where
there i
s fl
uorescent lamp or wireless telephone;
remote controller should be close to indoor unit
during operation.
Replace new batteries of the same model when
replacement is required.
When you don
'
t use remote controller for a long time,
please take out the batteries.
If the display on remote controller is fuzzy or there
'
s
no display, please replace batteries.
Press the back side of remote controller
marked with " ", as shown in the fig, and then
push out the cover of battery box along the
arrow direction.
Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
Reinstall the cover of battery box.
2.
1.
3.
battery
Cover of battery box
remove
reinstall
button
WiFi
●
This function is only available for some models.
Press "WiFi" button to turn on WiFi function, "WiFi"
icon will be displayed on the remote controller;
Hold "WiFi" button for 5s to turn off WiFi function
and "WiFi" icon will disappear.
Under off status, press "MODE" and "WiFi" buttons
simultaneously for 1s, WiFi module will restore
factory settings.
NOTICE
