button
●
●
●
/
button
Press this button to turn on the unit. Press this button
again to turn off the unit.
N
OTE
button
Introduction for buttons on
remote controller
button
button
Press this button to increase set temperature. Hold-
ing it down above 2 seconds rapidly increases set
temperature. In Auto mode, set temperature is not
adjustable.
AUTO
COOL
DRY
HEAT*
(*Notice: Only for models
with heating function.)
FAN
10
Each time you press this button, a mode is selected
in a sequence that goes from Auto, Cool, Dry, Fan,
and Heat*, as the following:
This is a general use remote controller. It could be
used for the air conditioner with multifunction. For the
functions which the model doesn't have, if press the
corresponding button on the remote controller, the
unit will keep the original running status.
After putting through the power, the air conditioner
will give out a sound. Power indicator " " is ON.
After that, you can operate the air conditioner by
using remote controller.
At ON status, after each pressing button on remote
controller, the signal icon " " on remote controller
will flash once. Air conditioner will give out a sound,
which indicates the signal has been sent to air condi-
tioner.
button
OFF
Press this button to set up & down swing angle,
which circularly changes as below:
After energization, Auto mode is defaulted. In Auto
mode, the set temperature will not be displayed on
the LCD, and the unit will automatically select the
suitable operation mode in accordance with the room
temperature to make indoor room comfortable.
(As for cooling only unit, it won't have any action
when it receives the signal of heating operation.)
●
indicates the guide louver swings as:
Auto
This remote controller is universal. If any com-
mand , or is sent out, the unit will carry
out the command as
Low speed
High speed
Medium speed
This button is used for setting Fan Speed in the se-
quence that goes from Auto, , , to to then
back to Auto.
●
●
●
Having set X-FAN function on: After turning
off the unit by pressing ON/OFF button indoor
fan will continue running for a few minutes. at
low speed. In this period, Hold fan speed
button for 2s to stop indoor fan directly.
X-FAN function Hold fan speed button for 2s in
COOL or DRY mode, the icon “ ” is displayed
and the indoor fan will continue operation for a
few minutes in order to dry the indoor unit even
though you have turned off the unit. After energi-
zation, X-FAN OFF is defaulted. X-FAN is not
available in AUTO, FAN or HEAT mode.
This function indicates that moisture on evapo-
rator of indoor unit will be blowed after the unit is
stopped to avoid mould.
Having set X-FAN function off: After turning
off the unit by pressing ON/OFF button, the
complete unit will be off directly.
Press this button to decrease set temperature. Hold-
ing it down above 2 seconds rapidly decreases set
temperature. In Auto mode, set temperature is not
adjustable.
SWING
