Sinclair ASC-60AN, Руководство пользователя

Страница: 14 / 20

Swing operation
Use the DIRECTION/SWING button to adjust the horizontal louver, use the SWING
button to adjust the vertical louver.
1. Press the SWING or ( ) button, the horizontal or vertical louver will swing
automatically. when press the AIR DIRECTION button, the louver changes 6
degree in angle for each press.
NOTE:
When the louver swing or move to a position which would affect the cooling
and heating effect of the air conditioner, it would automatically change the swing/
moving direction.
Timer operation
Press the TIMER ON button can set the auto-on time of the unit. And press the
TIMER OFF button can set the auto-off time of the unit.
To set the Auto-on time.
1. Press the TIMER ON button. The remote controller shows TIMER ON, the last
Auto-on setting time and the signal "h" will be shown on the LCD display area.
Now it is ready to reset the Auto-on time to START the operation.
2. Push the TIMER ON button again to set desired Auto-on time. Each time you
press the button, the time increases in 30 minutes increments, up to 10 hours,
then at 1 hour increments up to 24 hours.
3. After setting the TIMER ON, there will be a one-half second delay before the
remote controller transmits the signal to the air conditioner. Then, after
approximately another 2 seconds, the signal "h" will disappear and the set
temperature will re-appear on the LCD display window.
To set the Auto-off time.
1. Press the TIMER OFF button. The remote controller shows TIMER OFF, the last Auto-off setting time and the
signal "h" will be shown on the LCD display area. Now it is ready to reset the Auto-off time to START the
operation.
2. Push the TIMER OFF button again to set desired Auto-off time. Each time you press the button, the time
increases in 30 minutes increments, up to 10 hours, then at 1 hour increments up to 24 hours.
3. After setting the TIMER OFF , there will be a one-half second delay before the remote controller transmits the
signal to the air conditioner. Then, after approximately another 2 seconds, the signal "h" will disappear and the set
temperature will re-appear on the LCD display window.
IMPORTANT
The effective operation time set by the remote controller for the timer function is limited to the following settings:
0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, 4.0, 4.5, 5.0, 5.5, 6.0, 6.5, 7.0, 7.5, 8.0, 8.5, 9.0, 9.5, 10, 11, 12, 13, 14, 15, 16, 17,
18, 19, 20, 21, 22, 23 and 24.