Sinbo SFH 6929, Инструкция по эксплуатации, Страница: 3 / 10

- 2 -
15. If the supply cord is damaged, it must be replaced the manufacture or its service
agent or a similarly qualified person must replace it in order to avoid a hazard.
16. Do not use the appliance for other than its intended use as described in this instruction
book.
17. Do not place the heater immediately below a socket outlet.
18. This appliance is intended for household use only.
19. Do not leave the heater on overnight.
20. While cleaning, make sure not to use a wet cloth or use water on any part of the unit,
as this may cause a short circuit or electrical shock.
21. Do not use this unit in any area where water present.
22. Make sure the power cord is placed at the back away from the front panel of the
heater.
23. This appliance is not intended for use by persons (including children)with reduced
physical, sensory or mental capabilities or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
24. Children should be supervised to ensure that they do not play with the appliance.
25. Caution: Do not cover anything on your heater when in use.
26. The fan-heater must not be placed near a socket and the following hint: This fan-
heater must not be used near a bath, shower or swimming-pool
27. This heater is not equipped with a device to control the room temperature. Do not
use this heater in small rooms when they are occupied by persons not capable of leaving
the room on their own, unless constant supervision is provided.
NOTE: Should the unit overheat, this heater is fitted with a safety with overheating device
which will switch the off automatically. (If the air vent is blocked or if the fan function is
not blowing air). If this should happen, all you need to do this:
Disconnect the plug from the electrical socket for a few minutes. Ensure the heater is
not covered and nothing is obstructing any of the vents. Plug the heater back into the
electrical socket and switch the heater back ON.
KEY/PARTS LOCATION
1. ON/OFF switch control
2. Upper air grid
3. Nether air grid
4. Air out let
5. Indicator light
HOW TO OPERATE
1. Remove the unit from the box and take off any protective wrapping.
2. Place the heater on a smooth level surface and least 30cm away from any obstacles.
3. Plug your fan heater into the power supply. Make sure your power supply corresponds
1
2
3
4
5