OPERATINGYOUR SEALER
Step 1. Turn the Power Switch Off
Open the top cover by lifting the lid. If the
lid is locked, push down on both left and
right corner spots marked “lock” to
release the cover.
Step 2. Set the Seal Time
Set the seal time by adjusting the seal time
by pressing “+” or “-” based on bag
thickness. We suggest starting at either 3
or 4.
b.
Place bag to be vacuumed so that
nozzle is fully inserted into the bag.
c.
Bring the lid down and lock in place.
You should hear a “click” on both
right and left sides when the lid is
locked.
TIPS & NOTES
•
Note that after sealing a few packages,
MAINTENANCE INSTRUCTIONS
Installing the New Wire & PTFE
Adhesive
1. Replacing Heating Element. Attach
the new element to the spring hook
and run the element along the jaw
of the vacuum sealer. Attach the
other end of the element to the
spring hook on the other side. The
wire that juts from the heating
element is then wrapped around the
post.
Wrap wire
around the
post
Step 3. Start the Vacuum Process
a.
Extend the snorkel (nozzle) forward
by pulling the snorkel slide forward
until it locks into place.
d.
Turn on the power switch and the
sealer will begin the vacuum process.
Step 4. Start the Sealing Process –
the “Double Press Method”
a.
After you are satisfied with the
vacuumed bag, momentarily press
down on the seal bar and release so
that the nozzle retracts.
b.
Quickly push down again on the seal
bar with even pressure until the seal
light flashes and you hear a beep
indicating the seal is complete.
•
Note that after sealing a few packages,
you may have to drop your setting down
by one or two settings as it will take less
time to seal additional bags
TIPS & NOTES
•
Please do not press the seal bar when
there is no bag to be sealed. This could
damage the sealing edge
2. Replacing PTFE Adhesive. Remove
the backing on the adhesive. Apply
the adhesive over the elements. A
good rule of thumb is to replace the
PTFE adhesive every time you
change the element.
