GETTING TO KNOW YOUR SINBO
SINBO is a simple and effective vacuum sealer and the ONLY household unit that
can seal standard vacuum bags instead of the expensive channel vacuum bags.
DZ-280/2SE – ALL IN ONE SEALER
Our DZ-280/2SE is equipped with a filter canister which allows liquids and some
powder to be vacuumed sealed. In order to use the vacuum sealer, please note that
set up instructions differ slightly from our other sealer models.
Vacuum Sealing Liquids and Powders
1. Attach each long tube to the attachments at the back of the sealer. Connect the
tubes to the filter canister. Attach jar holder to the back attachments and
tighten to stabilize the jar holder
2. Make sure the filter canister lid is tightened fully
TIPS & NOTES
•Empty filter canister before the canister is
half full
•Clean the nozzle and canister after each
use
•Tighten canister lid fully for proper
vacuum
Power Switch
Turn on when
you are ready to
start the vacuum
process
Seal Time Counter
Adjust seal time
based on your
bag thickness
Lock
To unlock and open , press both
sides on the lock
Nozzle Slide Switch
Switch allows you
to bring nozzle
forward
Seal & Vacuum Light
Flashing light
indicates either
sealing or vacuum
mode
Sealing Bar
Pushing the
Power Cord
Always check your power
source for the correct voltage
Vacuum Sealing - General
1. Connect the two hose attachments at the back of the sealer with the short tube
sides on the lock
To lock and close, press down on
both sides of the lock
“Click” will signal unlock and lock
Nozzle
Nozzle draws the air out
of your vacuumed bag.
Nozzle should be
inserted in your bag
Pushing the
bar down
will end the
vacuum
process and
initiate the
sealing
process.
Follow our
“Double
Press”
method for
best sealing
results
PTFE Adhesive
PTFE adhesive ensures a smooth
seal. Replace adhesive and wire
underneath occasionally for best
sealing results
Lid Latch
Locks the lid
to the base
Leak Prevention Pads
The upper and lower
pads assist in the
vacuum sealing
process.
TIPS & NOTES
•
DO NOT
seal liquids or powders without
the filter canister as that will damage your
sealer
