Page
3
of
5
Mounting, Controller Placement and Connection
1.
Locate the ‘Main Enclosure Base’.
2.
Locate the ‘Controller’
3.
IMPORTANT
-
Place the ‘Controller’ up to 6ft of where your ‘Main Enclosure Base’ will be mounted. Make sure to
place the ‘Controller’ as far away from the PC and other electrical wiring / cabling as possible due to possible EMI.
4.
Se
curely mount the ‘Main Enclosure Base’ to your simulator or sturdy table using the supplied M6 screws that are
attached to the bottom of the ‘Main Enclosure Base’. You may also be using our AccuForce Angle Bracket and you
should secure it now as well.
WARNING:
Ensure that your mounting can withstand up to 16Nm of rotational force.
5.
CAREFULLY Connect the cable
that exits the rear of the ‘Main Enclosure Base’ to the ‘Controller’.
with two
connectors that look like this:
6.
Take note of the smaller connector and the placement of the tab at the top. (see arrow above)
7.
Carefully connect the smaller connector first
Be VERY careful to properly insert it. Note the placement for the tab
(arrow below)
8.
Then plug in the larger connector and make sure the clasp at the top locks and that both are firmly connected.
WARNING:
Please take note of the 10 gold pins on the smaller port. Incorrect installation of these connectors
could create functionality issues. Be careful to properly insert them.
