4/6
« Closing force » function
8
1- Position the motor to the
halfway position
using the “Down” or “Up” button. Press the “Stop” button to stop the awning.
2-
To activate
closing force function
press twice successively:
- 1
st
press: For half a second press simultaneously
“Stop” and “Up” buttons, without the motor rotating.
- 2
nd
press: For more than 3 seconds press simultaneously
“Stop” and “Up” buttons, until the motor jogs.
The motor is now in programming mode for only 10 seconds, the motor is factory set at the medium level.
3-
To increase the closing force
, press the
“Up” button until the awning makes a slow movement,
the cassette awning’s
closing force has moved up a level.
-
To decrease the closing force
, press the
“Down” button until the awning makes a slow movement,
the cassette
awning’s closing force has moved down a level.
4- Confirm the new setting by pressing
2 seconds the “Stop” button
, until the motor jogs.
The new setting is memorized.
This function allows the closing force of the awning cassette to be increased or decreased to 3 levels high-medium-low.
Contact the awning’s manufacturer before using these functions to check the compatibility of your systems.
For safety reasons, this function can only be accessed via the individual control point in 3 situations:
- After the settings confirmation and before programming the first control point.
- After programming the first control and during the next 4 cycles.
- After a single power outage and during the next 4 cycles.
2s.
3s.
+
0,5s.
1-
2-
3-
4-
Recommendations when using a sensor:
If the Wind sensor on an installation is changed or deleted, it is important to
delete it from the memory of all the motors in which it was programmed.
Programming a sensor
7
7.1- Open the memory of the motor from the individual control
transmitter:
- Press the “
PROG
” key of the transmitter for about
3 seconds
. The motor
will run for 0,5 second in one direction and then in the other.
7.2- Confirm the operation from the sensor you wish to add :
- Press the “
PROG
” key of the sensor less than
1 second
. The motor will
run for 0,5 second in one direction and then in the other.
PROG ≥ 3s.
1
2
>>
PROG ≤ 1s.
1
2
>>
- For group controls, repeat operations 7,1 and 7,2 for each motor in the group.
- To delete a sensor from the motor’s memory: Perform operation 7.1 from the individual control transmitter and operation
7.2 from the automatic control to be deleted.
i
i
