3/4
If you do not want to use this transmitter as the individual control:
- cut the power supply (2 seconds minimum).
- repeat the opération 4.1* with a new transmitter and then go to step §5.
* In this case, the motor will run for 0,5 second in both directions, that means the limits setting is already done.
>>
PROG 1s
>>
PROG 1s
>>
PROG 3s
2s
- Press the transmitter “PROG” Key for approximately 1 second.
The motor will run for 0,5 second in one direction and then in the
other.
Your transmitter is now programmed to control the
motor in stable mode.
6.2- Validate the operation from the new transmitter you
want to programm:
- Press the “PROG” key of the transmitter for about 1 second.
The motor will run for 0,5 second in one direction, then in
the other.
1- Position the motor on the UP end limit previously set in
§4.3b with the UP key.
2- Press simultaneously for 5 seconds the UP and DOWN
keys, The motor will run for 0,5 second in one direction
and then in the other direction.
3- Adjust the new position with the UP and DOWN keys.
4- Validate the new position by pressing 2 seconds the STOP
key. The motor will run for 0,5 second in one direction
and then in the other direction. The new end limits
setting is memorized. 3/4
8.1- Re-adjustement of UP end limits:
6.1- Open the memory of the receiver from the control
transmitter:
- Press the “PROG” key of the transmitter for about 3 seconds.
The motor will run for 0,5 second in one direction, then in
the other.
4- After the adjustment of the DOWN (a) and the UP (b) end limits, confirm the settings:
- Press 2s on the “stop” key to validate the settings. The motor will stop and will run for 0,5 second in
one direction and then in the other. Go to next step.
Programming the first individual point of control
5
Programming a new (individual, group or main) control point:
6
Recording and controling intermediate position
7
Re-adjustement of end limits
8
- This operation can only be performed from the transmitter that was used for operation 4.1.
5s
Recording:
- Position the motor on the wanted
position.
- Press 5 seconds on the “stop”
key. The motor will run for 0,5
second in one direction and then
in the other.
0.5s
1
2
3
4
5s
2s
Controling:
- Press on the “stop” key
for 0.5 s. the motor
goes to the intermediate
position.
- For group controls, repeat operations
6.1
and
6.2
for each motor in the group.
- For main controls, repeat operations
6.1
and
6.2
for each motor in the installation.
- To delete an transmitter from the memory of a motor, perform operations
6.1
with a programmed transmitter, then perform the operation
6.2
with the transmitter to be deleted.