Simtronics TLU 600, Руководство пользователя

Страница: 12 / 21

TLU 600/610 Page 11/20 NOSP 14540-04 (JULY 2011)
Press function key F3 (FORW) to view the next remote sensor.
Each line is numbered. Press the key for that line number (1 to 9) to communicate with
the corresponding remote sensor.
Up to this point, the menus have been in French. From this point onwards, the language
used will be that programmed into the remote sensor (French, English, etc.).
A green LED in the remote sensor’s infra-red head will, until this point, have been
flashing at a frequency of about 0.5 Hz. From the moment you select this remote sensor,
the flashing rate will increase to 1 Hz to indicate that communication has been
established and will remain at this frequency throughout the dialogue. This makes it
easier to identify the selected sensor, and shows that communication is taking place.
3.4.
3.4. 3.4.
3.4.
PICTOGRAMS
PICTOGRAMS PICTOGRAMS
PICTOGRAMS
A number of symbols called pictograms are used to simplify TLU 600/610 operation.
These pictograms appear in the right-hand column (20
th
column of the screen).
3.4.1.
3.4.1. 3.4.1.
3.4.1. C
C C
C
HARGE INDICATOR HARGE INDICATOR HARGE INDICATOR HARGE INDICATOR
:::: """" """"
When the battery is charging, the " " pictogram appears on the right of the screen
as shown below:
Figure Figure Figure Figure 6 66 6: : : : battery charging indicator battery charging indicator battery charging indicator battery charging indicator
3.4.2. 3.4.2. 3.4.2. 3.4.2. L L L L
OW BATTERY LEVEL IND OW BATTERY LEVEL IND OW BATTERY LEVEL IND OW BATTERY LEVEL INDICATOR ICATOR ICATOR ICATOR
:::: """" """"
When battery voltage falls to its lower limit, the " " pictogram appears on the
right of the screen as shown below:
Figure Figure Figure Figure 7 77 7: : : : low battery level indicator low battery level indicator low battery level indicator low battery level indicator
The battery must then be recharged using the charger supplied. (see chapter 3.4.5:
Battery recharging, page 13).
Do not continue to use the remote controller longer than half an hour after this
symbol first appears without recharging the battery. To do so could damage the
battery unit.