922-00027001/2.2
35
Context
The
Fish Sensors
page is the first tab in the
Sensor Setup
dialog box. This page allows you to
define which PI/PX catch monitoring sensors shall be used with the FM90 system.
Procedure
1
Click the
Sensor Setup
button.
This button is located on the top bar.
Observe that the
Sensor Setup
dialog box opens.
2
Select the
Fish Sensors
tab.
3
Select each sensor you want to set up (from sensor one to six) and click the
Add
Measure
button to add a measure for each sensor.
4
Set the sensor properties for each measure that you add.
a
Select the
Update Rate
for the catch monitoring sensor.
This parameter is used to select how often the FM90 can expect to receive
information from the sensor. A faster update rate gives you information more
often, but will decrease the battery life.
Note
The
Update Rate
parameter is very important. The value you choose
here must comply to the value programmed into the sensor. If these do not match,
the communication between the FM90 and the sensor will not work.
If you use the Simrad PX MultiSensor, the
Update Rate
is fixed. You must always
choose Normal update rate.
b
Select the
Position
.
For sensors that measure roll or pitch, choose either
Port
or
Starboard
. For all
other measurements, set this value to
Other
.
5
For each new catch monitoring sensor you add, repeat the following steps.
a
Select the measurement
Type
.
This setting defines the type of measurement that is expected from the catch
monitoring sensor. The type must match the actual type of measurement made
by the sensor.
b
Select the communication
Channel
.
This is the communication channel used between the catch monitoring sensor
and the FM90.
Содержание FM90
Страница 2: ......
Страница 140: ... 2018 Kongsberg Maritime ...